Water Fraction
Suspension dewatering efficiency is measured at the boundary between the forming section and the press section of a paper machine. This exit water content, known as couch roll moisture, represents the remaining percentage of water in the web before it enters the mechanical press nips. The property is typically expressed as a percentage of total sheet weight, ranging from seventy to eighty percent water.
Pressing Influence
Mechanical extraction of water is far less expensive than thermal drying. High couch roll moisture forces the press section to work harder, which raises the risk of web breaks under high nip pressures. Sheet density and surface smoothness are also affected when too much moisture remains in the web during the initial pressing stages.
Runnability depends on keeping this value within a narrow band of two percent.
Energy Cost
Steam consumption in the dryer cans rises when the press section cannot compensate for a wet sheet. Uncontrolled couch roll moisture leads to a higher thermal load, which increases the cost per ton of produced board. When the mill runs heavyweight testliner, any deviation in the initial drainage rate translates into reduced line speed.
The drying capacity of the machine acts as the final limit on production rate.