Initial Cohesion
Adhesive wet strength measured immediately after joining substrates resists mechanical separation prior to chemical curing or drying. The green tack of water-based adhesives holds folded paperboard flaps in place during high-speed carton assembly. Wet bond integrity relies on capillary forces and initial polymer entanglement before carrier water dissipates into paperboard fibres.
Measurement boundaries end once solvent evaporation or heat setting completes solid bond formation.
Setting Rate
Pressure applied during compression sections forces liquid adhesive into porous paperboard surface structures, initiating immediate mechanical keying. Water absorption into the board increases solids content within glue lines, rapidly increasing wet cohesive strength before full cure occurs. Formulations with high initial polymer concentration exhibit rapid green tack development, preventing flap pop-up on springy recycled linerboard grades.
Viscosity increases during open time build internal cohesive resistance against spring-back forces exerted by creased folding carton blanks. Rapid compression cycles demand high initial holding force to maintain container geometry on automated packaging lines. Substrate porosity variations change water absorption rates, altering setting speeds across different board grades.
Open Limit
Excessive open times allow adhesives to skim over before compression, reducing contact area and eliminating initial holding power. Skimmed adhesive films fail to wet opposing board surfaces, producing weak joints that separate during distribution. Board moisture content directly governs setting rate window limits.