Pulse Frequency
Primary frequency at which an ultrasonic sensor is designed to vibrate determines the wavelength and the depth of penetration into a material. Transducer center frequency is the midpoint of the range of frequencies the device emits when excited by an electrical pulse. Selecting the correct value is critical for balancing the need for fine detail with the ability to pass through thick or porous board.
Resolution Tradeoff
Higher values provide better spatial resolution but are more easily absorbed by the air and the internal fibres of the sheet. A transducer center frequency of one megahertz might be used for heavy corrugated board where deep penetration is needed. Conversely, a five megahertz sensor is better suited for thin coated papers where measuring very small differences in thickness is the priority.
The choice depends on the specific attenuation characteristics of the substrate being tested.
Wave Penetration
Broadband sensors can operate across a wider range than the nominal value but are still most efficient at the peak. If the transducer center frequency is mismatched to the board thickness, the signal will be too weak for accurate detection. This mismatch results in a loss of data precision and can hide defects that would be visible at the correct frequency.