Transient Delay
Heat transfer resistance across packed freight slows the equalization of internal core temperatures relative to ambient exterior fluctuations during transit. In sea and surface freight, cargo thermal lag describes the phase delay and amplitude reduction of temperature waves moving inward through pallets of corrugated boxes or bulk paper reels. Because dense fibre packs possess notable thermal mass combined with low thermal conductivity, rapid outside temperature swings do not penetrate the packaging immediately.
The property governs how long internal surfaces stay colder or warmer than surrounding convective air. Once ambient temperature drops below the dew point of warm air trapped in the load, or conversely when hot humid air hits a cold freight core, condensation risks multiply. This boundary breaks down once dwell times exceed several days, causing the entire thermal mass to match average ambient conditions.
Convective Mechanism
Heat exchange between shipping container air and packed goods proceeds via boundary-layer convection at outer carton faces, followed by conductive transmission inward across nested linerboards and air pockets. When a vessel sails into warmer tropical waters, exterior air warms rapidly while the pallet core retains departure temperatures, yielding steep local temperature differentials. Cargo thermal lag keeps corrugated fluting below the surrounding air temperature, lowering the temperature of the air film directly adjacent to board surfaces.
If that film cools below its saturation temperature, moisture leaves the vapor phase and settles directly onto the container liners. Water absorption drops stacking compression strength in boxboard walls rapidly. Pallets positioned near steel container walls experience faster thermal adjustment than those packed at the centre.
Solid bleached sulphate boards, having higher bulk density than unbleached kraftliner, exhibit different thermal diffusivities that alter temperature transfer rates.
Vulnerability Limit
Condensation risks derived from thermal delay concentrate primarily during the initial forty-eight to seventy-two hours of entering a distinct climatic zone. Thermal lag stops functioning as a buffer once ambient conditions equilibrate through the entirety of the corrugated volume. When external temperatures cycle cyclically between day and night, lag characteristics dictate whether condensation happens on interior box walls or container ceilings.
Secondary exterior insulation wraps damp the rate of thermal exchange to suppress these phase-shifted condensation points. Total heat capacity of the goods thus governs transit stability during intermodal routing.