Extraction Method
Manual collection of raw material samples from a moving production stream provides a rapid assessment of pulp or slurry consistency before sheet formation. Implementation of dynamic grab sampling ensures that the extracted portion represents the bulk material at that specific moment of production. The technique bypasses automated bypass loops to capture a physical snapshot of the chemical composition.
Rapid extraction enables immediate laboratory testing for wet end additive concentration.
Volume Consistency
Volume changes in the extracted liquid can introduce errors in the measured ratio of solids to water in the paper pulp. Accurate execution of dynamic grab sampling requires that the collector vessel remains in the stream for an identical duration across all testing cycles. Varying the immersion time alters the concentration of suspended fibres and light additives due to turbulence around the neck of the container.
Technicians utilize specialized sliding gates to stabilize the inflow rate and maintain a uniform volume of three liters per grab. Standardizing this volume minimizes statistical noise in the downstream laboratory reports and ensures that chemical adjustments are based on solid data.
Quality Control
Periodic testing of the collected slurry confirms the calibration of in-line optical sensors installed along the paperboard production line. Discrepancies resolved through dynamic grab sampling allow for manual recalibration of the optical instruments to avoid continuous over-dosing of sizing agents. A steady sampling schedule prevents chemical runaways that would otherwise waste expensive papermaking additives.