Deformation Gradient
Tensile elongation experienced by the exterior fibrous ply of a multi-layer board structure during folding defines the principal mechanical deformation governing score-line cracking. Packaging converters monitor outer liner strain to ensure that printed and coated outer carton surfaces withstand ninety-degree or one-hundred-and-eighty-degree bends without rupturing surface fibres. Calculated as the fractional change in surface length relative to initial unbent dimensions, the parameter quantifies how much outer plies must stretch when inner plies compress.
The metric applies strictly to scored folding boxboard and multi-wall corrugated board, ceasing at uncreased flat panels where bending stresses equal zero.
Tensile Allocation
Board thickness and hinge bend angle determine the physical magnitude of elongation imposed upon the external paper layer. During folding, the neutral axis of the board shifts inward toward the compression zone, forcing the convex outer face into extreme tension. When total caliper increases, outer liner strain rises proportionally because the surface sits farther from the neutral bending plane.
High-stretch extensible sack kraft or virgin chemical pulp liners tolerate elongation values exceeding six percent, whereas short-fibre recycled plies fracture when local strain exceeds two percent. Calendering pressure and coating formulations directly alter this tolerance, as heavy mineral pigments reduce available tensile stretch in the surface layer.
Converting Failure
Excessive outer liner strain causes visible liner splits that ruin decorative graphics and destroy structural rigidity on folding lines. Maintaining balanced scoring matrix geometries limits outer liner strain to safe operational ranges across varied board grades.