Thermomechanical Disruption
High-temperature mechanical processing units melt and disperse thermoplastic contaminants into microscopic particles within recycled pulp suspensions. Recycled board mills operate thermal dispersion systems to break down wax and hot melt adhesives before stock reaches the paper machine. The process combines elevated steam temperatures with intensive mechanical shear, smearing tacky contaminants across fibre surfaces so they no longer form visible specks or cause sheet breaks.
Operational limits restrict this process to heat-softening synthetic contaminants, as non-melting dirt particles remain unaffected by thermal treatment.
Temperature Threshold
Softening points of synthetic polymers dictate the operational temperature required for mechanical shear to break down contaminants. Executing thermal dispersion at temperatures above ninety-five degrees Celsius softens bitumen and hot melt adhesives, enabling disperger discs to knead them into invisible sub-micron specks. Operating below the melting temperature of targeted contaminants leaves sticky particles intact, causing them to blind forming fabrics and press felts downstream.
High steam pressure maintains pulp temperature inside the disperger housing, but excessive heat darkens mechanical pulps and accelerates fibre strength loss. Consistency of the incoming pulp plug must exceed twenty-eight percent to allow steam heating without condensing excessive water into the pulp matrix.
Energy Input
Specific energy consumption per tonne of pulp determines the degree of speck size reduction achieved during kneading. Increasing shaft speed and narrowing disc gaps during thermal dispersion raises energy input, improving ink detachment while fibrillating secondary cellulose fibres. Excessive mechanical action weakens recycled fibres and generates unwanted fine particles that reduce pulp drainage on the wire.