Rigid Compression Standard
Standardized testing for the compressive properties of unreinforced and reinforced rigid plastics involves applying axial loads to specimens until failure or a specific deformation occurs. While primarily used for bulk polymers, astm d695 provides the procedural basis for evaluating the crush resistance of heavy wall plastic containers or thick composite laminates. The document establishes requirements for specimen preparation and testing speed to ensure results remain consistent across different laboratories.
Structural Evaluation
Determining the compressive strength and modulus of a material allows for more accurate predictions of how structural components perform under heavy stacking loads. During the procedure, a universal testing machine compresses the specimen between two hardened steel platens at a controlled rate. The loading rate remains constant to prevent sudden impact forces from skewing the results.
Technicians observe the stress strain curve to identify the proportional limit where the material no longer returns to its original dimensions. This information is required for engineers designing shipping crates that must withstand vertical pressure during ocean transit.
Test Boundary
Validity of the results depends on the specimen maintaining its shape without buckling during the application of force. If the material exhibits a high length to diameter ratio, the test measurements shift from pure compression to flexural failure. This distinction ensures that the calculated modulus represents internal material stiffness rather than the geometry of the part.