Pressure Pulse
Stationary blade assemblies extract unbound liquid from forming fabrics through the generation of hydrodynamic vacuum pulses. Fourdrinier forming sections utilise hydrofoil dewatering to accelerate liquid removal without disrupting delicate initial fibre mats. As the wire glides over the contoured leading edge of the foil blade, a localized high-pressure pulse forms, followed by an immediate divergent angle that induces a low-pressure suction zone beneath the fabric.
This sudden vacuum draws free water downwards while simultaneously unsettling the suspended fibres, preventing early sheet sealing and improving sheet formation metrics.
Water Drainage
The trailing geometry of the foil blade peels away the extracted water film, directing effluent downward into the saveall pan beneath the table. In high-speed forming environments, hydrofoil dewatering generates drainage forces proportional to the square of wire speed, making blade profile selection central to machine drainage design. Flat foils support the moving fabric under heavy stock loads, while angled foils generate controlled suction pulses between one and three degrees of divergent pitch.
Gentle, distributed drainage pulses prevent pinholes and preserve fine fibres near the wire surface.
Angle Setting
Foil blades manufactured from high-density polyethylene or sintered ceramic wear over time, shifting the trailing divergence angle and weakening drainage efficiency. An excessive blade angle generates severe suction that pulls fines away from the wire side, aggravating sheet two-sidedness and undermining offset print uniformity. Careful positioning of foil sets ensures consistent drainage progression down the length of the forming table.