Operating Principle
Pneumatic metering represents a high-speed method for controlling liquid layer thickness on moving continuous webs of paper or paperboard. Standard air knife doctoring uses a continuous slot nozzle that directs a controlled sheet of compressed air against the wet coating layer shortly after application. This action shears off the excess liquid, leaving a uniform film that follows the surface contour of the substrate.
The method works well on rough, absorbent boards where blade methods would scrape high spots bare.
Coating Uniformity
Controlled air pressure and nozzle angle determine the final film weight across the web width. When line speeds change, the air pressure must adjust to maintain the target coat weight. Unstable pressure leads to variations in the dry finish.
Mechanical rigidity of the nozzle mounting prevents vibration, which would otherwise print a ribbing pattern into the liquid.
Viscosity Boundary
The rheological profile of the coating formula restricts the operation of this method to lower viscosity ranges. High solids coatings do not shear cleanly under the pneumatic stream. Thick suspensions resist the air stream, leading to splattering and uneven coverage.
Practical runs maintain a low viscosity to allow the air to act as a precise blade.