Force Transducer
Electromechanical transducers convert applied mechanical forces into proportional electrical signals through calibrated strain gauge bridges. Physical testing instruments utilize a load cell to measure compressive or tensile forces during paperboard strength evaluations. Internal metal flexures deform elastically under external mechanical loading.
Resistors bonded to the flexure body change electrical resistance proportionally to the applied surface strain.
Strain Measurement
Wheatstone bridge circuit configurations amplify minute resistance shifts generated within bonded strain gauges into readable voltage variations. Temperature compensation resistors cancel thermal expansion effects that could otherwise bias mechanical force readings during extended testing sequences. Signal conditioning electronics convert analog voltage outputs into high-resolution digital values for processing.
Calibration protocols apply certified dead weights across the operating range to establish precise voltage to force conversion factors. Non-linear responses indicate structural overload beyond the elastic limit of the internal metallic element.
Tensile Evaluation
Accuracy requirements for paper testing mandate load measurement precision within half a percent of full scale capacity. Fitting an appropriately sized transducer to a short-span compression tester ensures high signal-to-noise ratios during thin paperboard evaluation. Low-capacity transducers measure light web tension on slitter rewinders to prevent paper web breakages.
High-capacity units record peak compression resistance on corrugated shipping containers during box crush tests. Overload protection stops prevent mechanical damage when test samples shatter unexpectedly under heavy loading. Dynamic response speed must exceed loading rates to capture true peak failure forces without smoothing out peak values.