Thermal Barrier
Extrusion coating joins a molten polymer film directly to a fibrous substrate through the nip of a chilled pressure roll and a heated steel roll. Polyethylene lamination creates an impervious moisture barrier by bonding thermoplastic resins onto paper or paperboard webs at high line speeds. Molten resin oxidation on the air gap determines the final heat seal strength and the adhesion level achieved before the web enters the cooling station.
Melt index selection dictates the processing temperature range and the neck-in behavior observed during continuous web transit. Extruder screw design must generate uniform melt homogeneity to prevent pinholes and microscopic voids in thin extrusion coatings below twenty grams per square metre. Substrate moisture content exceeding six percent causes vapor bubble formation at the chill roll nip, which destroys barrier integrity across the entire converting width.
Adhesion Mechanics
Polymer anchorage depends entirely on mechanical keying into surface fibers and chemical oxidation of the molten curtain during its short transit through the atmospheric gap. Corona discharge treatment raises the surface energy of raw paperboard to a minimum of thirty-eight dynes per centimetre, which promotes wetting and polar bond formation without requiring chemical primers. Extrusion temperature profiles must balance rapid oxidation for bond strength against thermal degradation that produces unwanted odors in food packaging applications.
Chill roll temperature control regulates polymer crystallization kinetics, which directly influences the gloss level, friction coefficient, and final stiffness of the converted composite structure.
Barrier Performance
Water vapor transmission rates decrease exponentially as the polymer coating weight increases, provided the film layer remains completely free from pinholes or thinning edges. Creasing and folding operations induce micro-fractures in high density polyethylene layers, whereas low density grades maintain flexibility and barrier continuity under mechanical stress. Grease resistance relies on absolute film continuity rather than coating thickness alone, meaning extruder stability and gauge control dictate overall packaging performance in end use conditions.